Select Page

Tuftex® LSH-CB (Leaf Suction Hose)

Featuring a corrugated liner, this hose is produced using weather-resistant and excellent abrasion-resistant rubber compounds which provide a unique flexibility, ease of handling and long trouble-free service life not often associated with material handling hoses.

Features & Benefits

  • Abrasive resistant rubber liner
  • Double-ply synthetic fabric reinforcement
  • Abrasive resistant rubber cover
  • Spring steel wire helix support

Technical Overview

Inside Diameter (inches) 6 8 10 12 14 16
Approx.Weight (lbs./ft.) 3.6 4.2 6 8 10 12
Length Required for 90° Bend (inches) 16 18 22 27 31 39
Axial Tensile Strength 1000+ pounds
Temperature Range -40°F to +250°F
Negative Pressure to Collapse (inches hg.) 27 27 27 27 20 17

Tuflex Type LSH-CB is normally available in 20 foot lengths, however this product can be ordered in a range of diameter sizes and lengths

Coatings & Finishes

COATINGS
The coatings offered by Thermoid can reduce the loss of air and gases through the duct wall, increase abrasion and chemical resistance, reduce ducting flexibility, as well as the inside diameter of the duct, and increase the weight and wall thickness of the duct.
Available Coatings
  • Neoprene (CR) (Black) – Neoprene is the most commonly used industrial duct coating. It resists ozone, sunlight oxidation, heat and flame. Neoprene performs well in contact with oils, water and some chemicals. It has good tensile strength and resilience.
Maximum Recommended Coatings
  • Neoprene – 4 Coats (For coating, specify duct type and number of dip coats).
END FINISHES
The following end finishes are integrally manufactured into the ducting.
Soft End
ducting-soft-end
  • That portion of the duct where the wire reinforcement is omitted, having the same number of plies as duct body, plus one additional ply of fabric over soft area. This type of end provides a smooth clamping area.
Reduced End (Special)
ducting-reduced-end
  • The hose end has an ID that is smaller than the duct body. A rubber insert usually forms this end.
Plain End
ducting-plain-end
  • Hose with a plain end is simply cut at a given point, the end being the same as the duct body. The wire at the cut end is crimped back to prevent snagging. All standard items are furnished with plain ends.
Belled End (Special)
ducting-belled-end
  • A belled end has a soft end with an ID larger than the duct body.

More