Select Page

Aeroduct® Jet Starter Hose

The Aeroduct® Jet Starter Hose features a specially compounded seamless, non-flaking, silicone rubber tube that withstands temperatures up to 500°F and as low as -80°F and resists solvents, mildew and fuels. Harnessing the power of the starter, it delivers that power at full pressure and temperature to the plane.

Technical Overview

Pressure Hose – P/N 10H09

  • Hose liner is a smooth, seamless, non-flaking specially compounded silicone rubber that withstands temperature up to +500ºF and as low as -80ºF
  • Hose reinforcement is synthetic yarn for burst strength greater than 400 psi. Resistant to heat, solvents, mildew and fuels.
    Note: Construction insures each strand of yarn is integrally lock-bonded to the silicone tube.
Inside Diameter 3 – 1/2”
Wall Thickness 3/16” ± 1/32”
Weight per Foot 1.1 Pound
High Temperature +500ºF
Low Temperature -80ºF
Burst Strength Over 450 psig
Maximum Static Load 2000 Pounds
Proof Pressure Tested All lengths tested at 200 psig at Chanute
Lengths to 60ft

All data based on controlled tests and may be changed without notice

Literature

Thermoid Aviation Ducting and Hose Products – Brochure

Features & Benefits

  • Hose construction consists of a synthetic yarn reinforcement that assures high burst strength (400 PSI and higher), dimensional stability and maximum flexibility
  • Light enough to be handled easily by one person
  • Replaceable lenoweave or open-braided scuffer jackets extend service life. It provides an extra measure of abrasion resistance and durability by shielding the jet starter duct from the damage that often results from being dragged and scuffed over concrete ramps and runways.

More